umik-cal-nocal-behringer

The UMIK-1 with and without calibration file measured,
and the Behringer (no calibration file)
snoothed to 3db. The Behringer measurement mic offset by 25dB, but levels for it set arbitrarily on the mixer anyway

umik-cal-behringer-cal-nocal

Behringer with and without the generic calibration file applied, plus the UMIK with calibration as a reference

calibration-file-vs-cal-nocal-divided

The calibration file loaded into Holimpulse, plus the result of dividing the nocalibration measurement by the calibration measurement.. they are quite close except for being offset

umik-cal-nocal-behringer-nocal-superimposed

This is UMIK with and without calibration, and the Behringer without calibration, moved around so they are superimposed on to each other as closely as possible, zoomed in a bit.

umik-cal-behringer-nocal-superimposed

umik-with-and-without-calibration-smoothed-to-5-for-visibility

UMIK-1 measured with and without calibration applied.
Graph has been smoothed to 5 per octave to make it easier to see.

umik-1-nocalibrated-divided-by-calibrated-offset-smoothed-20

no calibration measurement, divided by calibrated.
smoothed to 20 for visibility, phase displayed to show mostly flat.
This is superimposed on the actual calibration curve supplied by miniDSP. To line them up exactly I had to add 2.8 dB to...

umik-1-nocalibr-ecm8000-no-calibr-smoothed-5

UMIK-1 and ECM 8000 both without any calibration, smoothed to 5 per octave for visibility, and the ECM8000 reduced by 6dB to line up closely with the UMIK-1 measurement

ECM-8000-calced-calib-with-umik-and-generic-smoothed20

Calculated ECM-8000 calibration curve (red). It has been offset by -6.5 to line up with 0dB, and the UMIK-1 calibration file and generic ecm-8000 calibration file are also shown (blue and green).
Smoothed to 20, although the imported calibration...